Kulak Kent Sitesi

()
12 ()
16 27

Continuous laser beam Continuous measurement and minimum/maximum measure-

If necessary, you can switch the measuring tool to continu- ment are not possible with the timer function enabled.
ous laser beam operation. To do this, select the settings for The timer remains enabled until the measuring tool is
the measuring tool using the soft key (3) [ ]. Use the but- switched off or until the timer is switched off in the settings
ton (4) [+] or the button (11) [–] to select the continuous menu.
laser beam and confirm this by pressing the button (13)
[Func]. Tool settings menu
u Do not direct the laser beam at persons or animals and Select the tool settings menu in the settings menu.
do not stare into the laser beam yourself (even from a Use the button (4) [+] or the button (11) [–] to select the
distance). required tool setting and confirm this by pressing the button
In this setting, the laser beam remains switched on even (13) [Func]. Select the required tool settings.
between measurements; measurement simply requires one To exit the tool settings menu (o), press the on/off/delete
brief press of the measuring button (2) [ ]. button (9) [ ] or the soft key (12) [ ].
The continuous laser beam can be switched off again in the
settings or automatically when the measuring tool is Tool settings
switched off.

Settings menu Language

To enter the settings menu (i), briefly press the soft key (3) Time & date
[ ] or press and hold the button (13) [Func]. ft/m Unit of measurement
Use the button (4) [+] or the button (11) [–] to select the Unit of measurement for angles
required setting and confirm this by pressing the button
TrackMyTools
(13) [Func]. Select the required setting.
To exit the settings menu, press the on/off/delete button (9) Tool information
[ ] or the soft key (12) [ ]. Tone signals
Settings Switch-off time
Dimmer
Bluetooth® Display brightness
Reference level Display orientation
Setting the language
Timer function
Select the language option in the tool settings menu. Set the
Continuous laser beam required language and confirm this by pressing the button
Grade measurement calibration (13) [Func].
Target indicator calibration Setting the date and time
Internal memory (deleting and formatting) Select the time & date option in the tool settings menu. Set
the date and time according to the instructions on the dis-
Tool settings play and confirm these by pressing the soft key (12) [ ].
Timer function Changing the unit of measurement
The timer function is useful when measuring in hard-to-reach Select the unit of measurement option in the tool settings
areas, for example, or when the measuring tool should be menu. The default unit of measurement is m (metres).
kept stationary during measurement. Set the required unit of measurement and confirm this by
Select the timer function in the settings. Select the required pressing the button (13) [Func].
time period between triggering the timer and starting meas- To exit the menu item, press the on/off/delete button (9) [
urement and confirm by pressing the measuring button (2) ] or the soft key (3) [ ]. The selected tool settings remain
[ ] or the button (13) [Func]. saved after you switch off the measuring tool.
Then press the measuring button (2) [ ] to switch on the
Changing the unit of measurement of an angle
laser beam and focus on the target. Press the measuring but-
ton (2) [ ] again to start the measurement. The measure- Select the option for setting the unit of measurement for
ment will begin after the set time period has expired. The angles in the tool settings menu. The default unit of measure-
measured value is displayed in the result line (a). ment for an angle is ° (degrees).
The time period between triggering the timer and starting Set the required unit of measurement for angles and confirm
measurement is displayed in the status bar at the top. this by pressing the button (13) [Func].

Bosch Power Tools 1 92A 4F4

nest...

99683 99684 99685 99686 99687